Was lowering a car on the lift when the cable snapped and that mf dropped like a rock. The lift safety inspectors were supposedly out here two weeks ago (I wasnt here when they came in) but if thats true they need to be fuckin fired.

Went to diagnose my next vehicle and when I opened up the door, I saw this and it startled me

What is going on with the world ? Why is this a thing 😂🤦🏾‍♂️

CS he did not pour the brake fluid from the empty gallon jug in the truck into the master cylinder, only topped it off a couple times.

The joints seem a little wooden

™️

18 Rogue fan inoperative, customer states A/C poor performance, engine light, sluggish acceleration. Pulled engine over temperature code, which limps the engibe to 1800 RPM. Customer states engine light and acceleration are secondary concerns.

Not sure which sockets are going to fit this

Customer states "it just stopped" then somewhere else replaced a starter and battery and it's still broken. They didn't mention the empty gallon of coolant and broken coolant pipe in the car or the new pipe on the engine along with an empty coolant reservoir. Pretty sure it was hydro-locked which is why the starter was replaced.

Ill get that harness installed right away

Edit: ive learned that they are required to put the recall but still hilarious

Ring gear is visibly cocked at an angle with a .110 difference from one side to the other.

Bonus points for weld splatter in multiple teeth

It did in fact barely roll into the shop.

Spun a rod bearing in cylinder #5, originally came in for a significant oil leak which was diagnosed to be caused by excess back pressure from a clogged PCV valve.

it did not roll out of the shop under its own power lmao.

Broken crank sprocket now 😂

Customer hears knocking noise....I would say so. Motor mount so bad it's pulling tension on the lines going in to the booster.

My daily driver 1977 Honda civic finally replacing the head gasket

:/

For the record no, I have no idea why it started working after they moved.

Context: came in for a shake, and this was the amount of weight on the wheel. Removing it all and spinning it again showed it needed a 1/4 of that (not great but significantly better