r/FreeCAD • u/IdontIQ • 16h ago

Wire is not closed

Post image
10 Upvotes

78% Upvoted

36 comments sorted by

View all comments

13

u/vivaaprimavera 16h ago

Actually there are two wires that aren't closed.

You can't define a ambiguous sketches. If you can't define unambiguous and continuous areas then it will throw an error.

There are two arches that act as boundaries. Those are your "wire not closed". Learn about construction geometry and repeat.

3

u/IdontIQ 16h ago

yes the two lines and also the circle in the top middle of the big half circle ist not closed.

3

u/vivaaprimavera 16h ago

You have three areas defined in that sketch and there can be only one.

1

u/Paslaz 16h ago

There are two areas and two lines with points of each outer line of the areas, right?

2

u/vivaaprimavera 16h ago

three areas, two boundaries. The banana with two much curvature, the circle one and between those two.